If your battery tender is connected to the battery you will NOT be able to toggle between modes with the select button. I initially had the battery tender connected to the battery and then gave it power. Once you do that, then you can connect the battery tender to the battery and you're all set! This way you will be able to toggle between the 2 settings and select Lithium Ion. If you need to toggle between the standard battery and lithium ion battery mode, connect the battery tender to your power supply but DO NOT connect the battery tender to the quick disconnect end that connects to the battery. This is fully explained in the manual if you buy the BMW branded charger from a dealer. The easiest and recommended place to install it is under the hood as seen in photos below You must connect the negative via the body. You can get errors with the Intelligent battery sensor that way. Since this part is designed to be used with the Brake Buddy supplemental braking system you can use the instructions from that part to install the charger. NOTE: This product has been discontinued in 2019, and has been replaced by the new Towed Battery Charger Plus. Transient voltage protection, so ignition spike protected. Maximum output is 30A continuous so you should be able to connect most of your farkles. 35mm height is to the top of the terminals which are provided with plastic covers. Avoid flat batteries and get a car that always starts. Some more details about the battery Buddy for you: Size: 77 x 52 x 35mm. Call 31 now to get a free estimate on auto electronic installation service in Cedar Rapids, Iowa. We'll install the features you need to make your car smarter and safer. You can connect it in the trunk, but you must not connect it to the battery negative terminal. Save time, money and the environment by ensuring that your battery is always fully charged. Automotive Electronics sells aftermarket products so you can customize your vehicle however you want. NOTE: DO NOT connect the alligator clips or the ring terminal quick disconnect ends to the negative terminal post on the battery in the trunk. If you dont want to do that you can just use the alligator clips but why would you want to have to put those on and take them off every time you use the battery tender? Use the ring connector option. You could unscrew it but that takes longer and is more effort. I had to route the wires reverse since i wanted to route it nice and clean out of the way, I was unable to route the positive end under the windshield washer reservoir because of the fuse, so i had to start from the other side (where the positive post is) and route the quick disconnect and the negative side under the windshield reservoir. You can connect it to the positive battery lead under the hood and the negative post (as seen in my video). It comes with either the alligator clips (what's used on jumper cables) or the ring terminal connectors which are a more permanent solution. It's a good idea to use a battery tender to keep your battery charged up as these cars have very expensive lithium ion battery. Or your M3/M4 isnt your daily driver and sits in the garage for long periods of time. If you are like me and live where it snows, you probably put your car away for the winter.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |